SharePoint
Aide
IRSN, Institut de radioprotection et de sûreté nucléaire

Search our site :

ok

Contact us :

ok
En Fr

Enhancing Nuclear Safety


Research

Publications

Characterizing surface-area of airborne nanostructured particles


Congress title :EuroNanOSH 2007 - Nanotechnologies: A Critical Area in Occupational Safety and Health
Congress location :Helsinki
Congress date :03/12/2007

Document type > *Congrès/colloque

Keywords > nanoparticles, surface

Research Unit > IRSN/DSU/SERAC/LPMA

Authors > BAU Sébastien, GENSDARMES François, THOMAS Dominique, WITSCHGER Olivier

Publication Date > 05/12/2007

Summary

  Although it is not clear which physical exposure metric play the most important rôle in the évaluation of the potential impact of nanostmctured particles (NP), several studies support the concept that the surface-area is the dose measurement that best predicts pulmonary toxicity to a broad range of airborne NP. Our work aims at theoretically and experimentally investigating the différent approaches applicable for characterizing airborne NP surface-area. Différent theoretical ways leading to surface-area estimation hâve been identified. The BET off-line method, used in toxicological studies for characterizing powders, is not well suited for measuring airborne surface-area of NP at low mass concentrations. Electron microscopy analysis provides différent information on collected NP (primary particle size, number of primary particles, fractal dimension etc.). However, this off-line analysis is time consuming and has stringent collection and préparation requirements. Another approach, combining independent simultaneous intégral measurements by direct-reading instruments, leads to an estimation of surface-area assuming some of the distribution parameters. From size distribution measurements, the surface-area distribution can be calculated, assuming some properties of the NP (morphology, density etc.). Few on-line techniques hâve been recently designed to measure surface-area of airborne NP, based on attachment rate of airborne markers (unipolar ions or radioactive atoms) to NP. Yet, there is a lack of data on the performances and on the parameters that could affect their responses.
To investigate some of the identified approaches, a specially designed expérimental set-up has been built, where properties of airborne NP can be varied (size, morphology, concentration, chemical composition etc.) in ranges thought to be relevant with the ones encountered in the workplaces. The set-up is composed of a spark discharge generator, a bipolar ion charger, and a high-temperature furnace. Two test modes can be explored with this facility: a polydisperse mode where four simultaneous instruments can be performed, and a monodisperse mode where the response of the tested instrument can be explored as a function of particle size. As a first step, the complète characterization of the set-up has been performed. Size distributions were measured with FMPS (Fast Mobility Particle Sizer) and SMPS (Scanning Mobility Particle Sizer) for différent électrodes in the spark discharge generator (C, Cu and Al). Electrical mobility diameters of NP vary in the range 10 up to about 200 nm. Number concentrations vary in the range less than 105 up to about 107 p/cm3. The stability and the reproducibility of the results are very good. The electric charge of the NP was measured with a Radial-Flow DMA. Fractions of neutral NP vary with the diameter of the particles; they are above 90 % for Cu and Al électrodes and less than 50 % for the C électrode. As a second step, several commercially available instruments or prototypes devoted for characterizing airborne NP in workplace atmosphères are under investigation.
 
Send Print

More about

Contact


Close

Send to a friend

The information you provide in this page are single use only and will not be saved.
* Required fields

Recipient's email:*  

Sign with your name:* 

Type your email address:*   

Add a message :

Do you want to receive a copy of this email?

Send

Cancel

Close

WP_IMPRIMER_TITLE

WP_IMPRIMER_MESSAGE

Back

Ok